JVC KD-R961BT Manuel D'instructions page 18

AUDIO SETTINGS
SUB.W PHASE * 1
REVERSE (180°)/ NORMAL (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
(Selectable only if a setting other than [THROUGH] is selected for
[SUB.W LPF].)
HPF (For KD-R961BT)
OFF: All signals are sent to the front/rear speakers. ; LOW 100HZ /
MID 120HZ / HIGH 150HZ: Audio signals with frequencies lower than
100 Hz/ 120 Hz/ 150 Hz are cut off from the front/rear speakers.
FADER R06 — F06 (00): Adjusts the front and rear speaker output balance.
BALANCE *
5
L06 — R06 (00): Adjusts the left and right speaker output balance.
VOL ADJUST –05 — +05 (00): Presets the volume adjustment level of each source
(compared to the FM volume level). Before adjustment, select the source
you want to adjust. ("VOL ADJ FIX" appears if FM is selected.)
AMP GAIN LOW POWER: Limits the maximum volume level to 30. (Select if the
maximum power of each speaker is less than 50 W to prevent damaging
the speakers.) ; HIGH POWER: The maximum volume level is 50.
D.T.EXP ON: Creates realistic sound by compensating the high-frequency
(Digital Track components and restoring the rise-time of the waveform that are lost in
Expander) audio data compression. ; OFF: Cancels.
SPK/PRE OUT Selects the appropriate setting to get the desired output.
*
1
Displayed only when [SUB.W] is set to [ON]. ( 15)
*
2
Displayed only when [SPK/PRE OUT] is set to [SUB.W/SUB.W].
*
3
For unit with 3-pair lineout terminals: Displayed only when [SPK/PRE OUT] is set to
[REAR/REAR] or [SUB.W/SUB.W].
*
4
For unit with 1-pair lineout terminals: Displayed only when [SPK/PRE OUT] is set to
[REAR/SUB.W] or [SUB.W/SUB.W].
* 5
This adjustment will not affect the subwoofer output.
16
SPK/PRE OUT
Connection via lineout terminals (
(For KD-R961BT)
Setting
FRONT
REAR/REAR Front speakers output Rear speakers output
REAR/SUB.W —
SUB.W/SUB.W Front speakers output L (left): Subwoofer output
(For KD-R864BT / KD-R862BT / KD-R861BT)
Setting
REAR/REAR Rear speakers output
REAR/SUB.W Subwoofer output
SUB.W/SUB.W Subwoofer output
Connection via speaker leads (
Setting
L (left)
REAR/REAR Rear speakers output
REAR/SUB.W Rear speakers output
SUB.W/SUB.W Subwoofer output
If [SUB.W/SUB.W] is selected:
– [HIGH 120HZ] is selected in [SUB.W LPF] and [THROUGH] is not available.
– [R01] is selected in [FADER] and selectable range is [R06] to [00]
)
25
Lineout terminal
REAR SW
Subwoofer output
— —
Subwoofer output
R (right): (Mute)
Lineout terminal
REAR/SW
)
25
Rear speaker lead
R (right)
Rear speakers output
Rear speakers output
(Mute)