Dometic TEC30EV Instructions De Montage page 27

TEC30EV
Item Description
26 6-pin plug
27 2-pin plug
10.4 Connecting 230 V
A
NOTICE!
• Connect the
system so that the generator is not damaged when the external
mains is connected.
• Ensure that the electrical system is set up as follows:
– TN network:
The neutral conductor must be linked to the PE conductor on the
terminal via a jumper with a minimum diameter of 2.5 mm
protect against automatic shutdown, make sure that a safety
switch (FI switch, 30 mA) and an in all-pole overcurrent
protection (e.g. circuit breaker, 13 A) are installed.
– IT network:
Ensure that an insulation monitor and an in all-pole overcurrent
protection (e.g. circuit breaker, 13 A) are installed.
• Connect the generator so that it takes priority over the power supply
(chapter "Creating a priority circuit" on page 29).
➤ Guide the 230 V connection cable through the cable passage in the housing and
connect it to the 230 V terminals (fig. g 5, page 10).
➤ Connect the earth cable to the earth connection on (fig. g 6, page 10).
10.5 Connecting the remote control
➤ Connect the remote control to the control panel of the generator using the
extension cable provided on the plug for the remote control (fig. g 4, page 10).
10.6 Connecting the float
➤ Connect the float from the tank to the Diesel oil gauge connection (fig. g 8,
page 10).
EN
Connecting the electrical power to the generator
relay AG 102 to the vehicle's electrical
changeover
2
. To
27