Télécharger Imprimer la page

Ryobi P321 Manuel D'utilisation page 10

Publicité

Les langues disponibles

Les langues disponibles

Driving too deeply into the material, excess debris, or jammed
nails may lead to the driver mechanism being stuck at its
bottom position.
The driver mechanism can usually be returned to its operating
position by depressing the workpiece contact against a scrap
piece of wood and squeezing the trigger.
If this does not automatically return the driver mechanism
into the tool, the tool may be jammed.
If a nail or fastener becomes jammed in the tool, remove
the battery pack and keep the tool pointed away from you
while clearing the jam.
 Remove battery pack from the tool.
 Open magazine and remove nails from the tool.
 Pull up on the latch and open the jam release.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts could create a hazard or cause
product damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
OPERATION
 Insert a flat blade screwdriver into the tip of the driving
mechanism and push the driver mechanism back, freeing
the nail jam.
 Remove the bent nail.
 Close the jam release and latch.
 Reinstall nails and close the magazine.
 Reinstall the battery, reactivate tool.
If the tool cycles without driving a nail, the nail channel may
be dirty. See Cleaning the Nail Channel in the Maintenance
section of this manual.
MAINTENANCE
CLEANING THE NAIL CHANNEL
See Figure 13, page 13.
If the tool will not drive a nail, or cycles without driving a nail,
glue residue from the nail strip may need to be cleaned from
the area around the driving mechanism.
 Remove the battery pack.
 Remove nails from the tool.
 Open the jam release latch and the magazine.
 Use a small amount of air tool oil on a clean cloth or cotton
swab to wipe down the nail channel, removing all traces
of glue.
 Reinstall nails in the tool and close the magazine.
10 — English

Publicité

loading