Technical Data - Hilti DD 200 Mode D'emploi

4. Technical data

Drive unit
Rated voltage*
Rated power input*
Rated current*
Rated frequency
en
Nominal speed under no load
Max. permissible water supply
pressure
Dimensions (LxWxH)
Weight (drive unit)
in accordance with EPTA procedure 01/2003
Weight (drill stand)
in accordance with EPTA procedure 01/2003
Drilling depth
Protection class as per EN/IEC 61029
-NOTE-
This equipment complies with the applicable standard provided that the maximum permissible mains supply impe-
dance (Z ) at the point where the user's installation is connected to the public supply network is less than or
max
equal to 0.363+j0.227 Ω. It is the responsibility of the installer or user of the equipment to ensure, by consultati-
on with the supply network operator if necessary, that the equipment is connected only at a point in the supply
with an impedance of less than or equal to Z
-NOTE-
The vibration emission level given in this information sheet has been measured in accordance with a standardised
test given in EN 61029 and may be used to compare one tool with another. It may be used for a preliminary assess-
ment of exposure. The declared vibration emission level represents the main applications of the tool. However if
the tool is used for different applications, with different accessories or poorly maintained, the vibration emission
may differ. This may significantly increase the exposure level over the total working period. An estimation of the
level of exposure to vibration should also take into account the times when the tool is switched off or when it is
running but not actually doing the job. This may significantly reduce the exposure level over the total working peri-
od. Identify additional safety measures to protect the operator from the effects of vibration such as: maintain the
tool and the accessories, keep the hands warm, organisation of work patterns.
Noise and vibration information (measured in accordance with EN 61029-1):
Typical A-weighted noise power level (L
Typical A-weighted noise emission pressure level (L
Wear ear protection
For the given sound power level as per EN 61029, the tolerance is 3 dB.
Total triaxial vibration values (vibration vector sum) at the hand wheel (star handle) a
Drilling in concrete (wet)
Uncertainty K
Typical weighted vibration at the handwheel
Uncertainty K
* The machine is available in several versions with different voltage ratings. Please refer to the type plate for the voltage rating and input power
rating of your machine.
20
Printed: 21.10.2015 | Doc-Nr: PUB / 5069597 / 000 / 04
DD 200
100 V 110 V
2300 W
15 A 22.5 A
50/60 Hz 50 Hz
320/640/1300 /min
6 bar
630×150×173 mm
13.9 kg
18.3 kg
max. 500 mm without extension
protection class I (earthed)
.
max
): 105 dB (A)
wA
): 92 dB (A)
pA
2,5 m/s
1,5 m/s
< 2.5 m/s²
1.5 m/s
220 V 230 V EU
2500 W 2600 W
12.2 A 12.3 A
50/60 Hz 50/60 Hz
265/550/1120 /min
2
2
2
230 V CH 240 V
2250 W 2600 W
10 A 11.8 A
50 Hz 50 Hz
h