Operation; Programming The Cooktop; Switching The Cooktop On And Off; Adjusting The Element - Thermador An American Icon CIS365GB Mode D'emploi

Operation

Programming the cooktop

Switching the cooktop
on and off
To switch on
To switch off
Indicators

Adjusting the element

This section will show you how to adjust the elements. The table contains details on
the heat settings and appropriate cooking times for a variety of dishes.
Connecting and disconnecting the cooktop using the main ON/OFF switch.
Press the ON/OFF symbol. A beep will sound. The " indicator located on top of the
ON/OFF symbol will appear.
Press the ON/OFF symbol. The " indicator will go out. The cooktop is switched off.
The residual heat warning light stays on until the elements have cooled down
completely.
The cooktop switches off automatically when all the elements have been switched
off for more than 20 seconds. The residual heat indicator remains lit until the
elements have cooled down sufficiently t/s.
The required heat setting can be adjusted using the programming zone.
Heat setting 1 = minimum
Heat setting 9 = maximum
Each heat setting has an intermediate step. This is shown by the .5 indicator
(e.g. 1.5).
Adjusting the heat setting:
The cooktop must be switched on.
1.
Press the O symbol on the desired element. The corresponding
indicator _ lights up.
2. Select the desired element using the 1 to 9 symbols or using the + and -
symbols.
15