Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
MAG
8 Maintenance and cleaning
8.1 Cable assembly
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power supply and cut off the gas supply.
• Pull the mains plug.
DANGER
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Check coolant hoses, seals, and connections for damage and tightness.
Replace as necessary.
• Always wear your personal protective equipment when performing
maintenance and cleaning work.
1 1 Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2 Unscrew nut and pull out liner and replace it, if necessary.
3 Remove worn parts from the torch neck .
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide liner with compressed air, wear suitable
protective clothing, in particular safety goggles.
4 Clean wire conduit from both sides with compressed air.
8 Maintenance and cleaning
EN - 9
Publicité
Table des Matières
