Roborock S4 Manuel Utilisateur page 30

Environmental protection description
The chemical substances contained in the built-in lithium-ion battery of this product can cause environmental pollution.
Before disposing of this product, remove the battery. The battery should then be properly recycled either through local authorities or
by providing the batteries to a battery recycling facility.
How to remove the battery:
Note:
The following information applies only when disposing of the robot or if the battery is no longer funvctioning normally. You will be able to recognize this problem if, even when
left to charge, the robot cannot clean due to a low battery. Do not remove the battery if you intend to continue using the robot.
1. Turn off the robot.
2. Unscrew the battery cover.
3. Remove the battery cover.
4. Press the clip to pull out the battery connector.
5. Remove the battery.
Note:
Before removing the battery, make sure it is fully drained. Do not attempt to remove the battery if the robot is connected to the charging dock.
Remove the entire battery pack. Avoid damaging the battery pack casing to avoid short-circuits or leakage of hazardous substances.
In the event of accidental contact with battery fluid, rinse thoroughly with water and seek immediate medical care.
All manuals and user guides at all-guides.com
027