Roborock S4 Manuel Utilisateur page 18

Instructions for use
Charging
Auto: After cleanup, the robot will automatically return to the
charging dock to recharge.
Manual: In Pause mode, press the
back to the charging dock.
The power indicator will flash slowly as the robot charges.
Note: If the cleanup was started away from the charging dock and the robot could not
return to the dock after cleanup, it will instead return to its starting point. Place the
robot directly on the dock to start recharging.
Error
If an error occurs while the robot is cleaning, the power indicator
will flash red quickly, and you will hear a voice alert. See
"Troubleshooting" for resolution options.
Note:
The robot will go to sleep automatically if left in an Error state for over 10-minutes.
Placing the robot on the charging dock in an error state will stop the current cleanup.
Reset WiFi
If your phone cannot connect to the robot because you have
changed your router configuration, forgotten your password, or any
other reason, open the top cover to see the WiFi indicator light then
press and hold the button and
"Resetting WiFi" voice alert. When the WiFi indicator light flashes
slowly, reset is complete.
Note: If the robot is left connecting to the network for over an hour, its WiFi will be
disabled. Reset WiFi before attempting reconnection.
All manuals and user guides at all-guides.com
button to send the robot
button until you hear the
Spot cleaning
In Standby or Pause modes, press and hold the
clean. A 1.5m x 1.5m square area centered on the robot will be cleaned.
After cleanup, the robot will return to the center of the square.
Note: Pressing any button will cancel the current spot cleanup
<
015
button to spot
<
1.5m