Adjusting Backrest Cover - Invacare Aquatec Ocean E-VIP Manuel D'utilisation

1. Place seat plate A on seat frame B with the cut out
facing to the front.
2. Slide the seat plate back as far as it goes.
3. Using the flat of your hand, press down on the sides
and then the front and back of the seat plate until the
seat plate clicks into the seat frame.
Removal
1. Pull up the seat plate on both sides.

4.7 Adjusting Backrest Cover

The tension of the backrest can be adjusted as desired.
WARNING!
– Make sure that at least three belts are always
passed by the backrest frame (on the outside)
and their belt buckles are closed.
1556395-D
Fig. 4-6
To attach accessories, the third belt from the top can
be opened and the backrest cover can be passed by
the backrest frame on the inside at point C.
Tightening:
1. Pull the belts A of the backrest cover tighter.
Loosening:
1. Open the buckles B by squeezing the retaining lugs
together (refer to arrows in Fig. 4-6).
2. Push the belts back a little through the buckle.
3. Close the belt buckles.
4. Retighten the belts gently.
WARNING!
Risk of Injury due to Damaged Backrest Buckles
Check for secure fastening of the backrest
buckles each time the product is maintained or
reconditioned.
– Check all buckle clips for secure fastening by
closing the buckles and pulling on both ends.
– Replace the backrest/backrest buckles if a
buckle opens under the applied force.
Fig. 4-7
Setup
15