Setup; Safety Information; Assembling The Product; Assembling Seat Frame - Invacare Aquatec Ocean E-VIP Manuel D'utilisation

4 Setup

4.1 Safety Information

WARNING!
– Check the parts for transport damage before
commissioning and contact your provider if
required.
– Ensure during assembly that the parts are
positioned correctly with respect to one
another.
CAUTION!
Risk of Pinching
– Take care during assembly.

4.2 Assembling the Product

This section describes the assembly. Disassembly takes place
in the reverse order.
The armrest height, footrest height, footrest angle,
heel strap, tension of backrest cover and accessories
must be adjusted to optimally fit the user.

4.3 Assembling Seat Frame

WARNING!
Risk of Injury or Damage
Bolts slipping out or coming loose can cause
injury or damage.
– Make sure that the safety clips engage and are
correctly fitted (see graphic below).
1556395-D
1. Press red foot lever down on the castors to secure all
castors.
2. Cut cable ties which are used as transport lock.
3.
A
B
E
D
Remove the drive for the seat tilt A from the chassis.
4. Push fork B at the lower end of drive A onto lip D at
the back end of the chassis and align the holes.
5. Insert bolt E (35 mm) into holes from the outside and
push it in completely.
6. Attach a safety clip C on the inside.
7.
D
C
Insert cable B of drive D as far as possible into chassis
A.
C
Fig. 4-1
A
B
Fig. 4-2
Setup
11