Installing The Headrest - Invacare Aquatec Ocean E-VIP Manuel D'utilisation

Aquatec® Ocean E-VIP
8. Use provided cable tie C to secure the cable of the
drive in this position.
The armrests face forward when folded down.
9.
G
H
I
J
Insert both sides of seat frame F into receivers H on
chassis J.
10. Insert two 35 mm bolts G into receivers H from the
outside. Push in completely and attach safety clips I
on the inside.
11. Tilt the seat frame until the holes in bracket E on the
seat frame and the holes in fork A on seat tilt drive
D are aligned.
12. Insert 23 mm bolt B into the holes from the outside
and attach safety clip C on the inside.
12
F
C A B
E
D
Fig. 4-3

4.4 Installing the Headrest

1. Use the star handle F to insert the screw a little into
the bracket G.
2. Push the bracket with the screw onto the handle of the
backrest E from behind with the screw engaging in the
hole of the backrest's handle.
3. Insert the plate D into the bracket from the front so
that both lugs of the plate face down and up and the
curved plate side touches the handle of the backrest.
4. Push the height adjustment tube C from above into
the recesses of the bracket.
5. Use the star handle to tighten the screw until the height
adjustment tube is fixed in place.
6. Push the pad J and the pad holder B into the holder
H on the height adjustment tube.
7. Use the star handle A to tighten the upper screw until
the pad holder is fixed in place.
1556395-D