Fitting Footrests - Invacare Aquatec Ocean E-VIP Manuel D'utilisation

11.
Reinstall armrest B on bracket C.
12. Fold down armrest.
13. Reinstall cap A.
14. Pass the open belt of the backrest cover on the outside
of the backrest frame, close and tighten all the belts.

4.9 Fitting Footrests

The right and left footrest are each installed in the
same way.
1556395-D
A
Fig. 4-10
F
G
H
1. Slide footrest A with footplate B inwards into the guide
G on seat frame F until groove E engages in the pin of
clip H. The footrest should no longer turn to the sides.
Setting Footrest Height
1. Pull footrest A up a little.
2. Pull out clip H and reinsert it in desired position. You
may need to pull the footrest out a little further to do
this.
3. Press down the footrest until groove E engages in the
pin of the clip.
4. Adjust second footrest to desired height the same way.
Removing / Installing Heel Straps
1. Open hook and loop fastener on heel strap D.
2. Remove screw C from bottom side of the footplate.
3. Remove screw and flexible pin with the heel strap.
4. Installing the heel straps take place in reverse order.
When installing a heel strap, make sure that the
hook and loop fastener faces backwards.
E
A
D
C
B
Fig. 4-11
Setup
17