Bar And Chain Combinations; Saw Chain Filing And File Gauges - Husqvarna 435 Manuel D'utilisation

Masquer les pouces Voir aussi pour 435:

Manuel d'utilisation (132 pages)

Manuel d'utilisation (120 pages)

Manuel d'utilisation (108 pages)

Table des Matières

Les langues disponibles

Recommended cutting equipment for Canada

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 435, 435e and 440e. The

combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-15 Chainsaws and Z62.3-

11 (R2016) Chainsaw Kickback standards.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the

corresponding maximum nose radius of a solid bar.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.

For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of

sprocket teeth may be considered to have equivalent kickback energy.

A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent

or less kickback energy than the sprocket-nose bar.

We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which

are available at your dealer.