Assembly; Fitting The Cutting Head (Saw Attachment With Shaft); Fitting The Cutting Head (Saw Attachment Without Shaft); Mounting Guide Bar And Chain - Husqvarna 91VG Manuel D'utilisation

Fitting the cutting head (Saw
attachment with shaft)
• Fit the cutting head on the
shaft so that the screw (A)
is aligned with the hole in
the shaft as shown.
• Tighten screw A.
• Tighten screw B.
NOTE! Make sure that the
drive shaft inside the shaft
engages with the cut-out in
the cutting head.
Fitting the cutting head (Saw
attachment without shaft)
• Remove the mitre gear
from the shaft.
• Fit the cutting attachment
to the shaft.
• Tighten screw A.
• Tighten screw B.
NOTE! Make sure that
the drive shaft inside the
shaft engages with the cut-
out in the cutting head.

Mounting guide bar and chain

• Unscrew the bar nut and
remove the guard.
• Fit the bar over the bar
bolt.Place the bar in its
rearmost position. Place
the chain over the drive
sprocket and in the groove
on the bar. Begin on the
top side of the bar.
• Make sure that the edges
on the cutting links are
facing forward on the top
side of the bar.
• Fit the clutch cover and
locate the chain adjuster
pin in the hole on the bar.
Check that the drive links
of the chain fit correctly on
the drive sprocket and that
the chain is in the groove
on the bar. Tighten the bar nut finger tight.
• Tension the chain by using the combination wrench. Turn
the chain adjuster screw clockwise. The chain should be
tensioned until it fits snugly on the underside of the bar.
14
– English

ASSEMBLY

• The chain is correctly
tensioned when there is no
slack on the underside of
the bar, but it can still be
turned easily by hand.
Hold up the bar tip and
tighten the bar nuts with
the combination wrench.
B
• When fitting a new chain,
the chain tension has to be
checked frequently until
A
the chain is run-in. Check
the chain tension regularly.
A correctly tensioned chain
gives good cutting
performance and long
lifetime.

Fitting the hanging ring

Fit the hanging ring between
the rear handle and the loop
handle. Position the hanging
ring so that the machine is
balanced and comfortable to
work with.

Adjusting the harness

You should always use the
harness with the machine to
A
give maximum control and
reduce strain on your arms
and back.
1. Put on the harness.
B
2. Hook the machine onto
3. Adjust the length of the
the hook on the harness.
harness so that the hook
is roughly level with your
right hip.