Techness RUN 200 TOUCH Mode D'emploi page 82

C: Transformer defective
D: Controller defective
A: Motor wire or motor defective
B: The connecting wire between
E2
the motor and controller is loose
or controller defective
A : speed sensor not in place
B: speed sensor defective
E3
C: The connect wire between the
speed sensor and the controller
not in place
D: controller defective
A: Controller defective
E5
B: Motor defective
C: Computer can not test the
E7
safety key signal
A:Handle pulse
disconnected or faulty
No pulse
B: Console circuitry defective
Console
A: The screw on the pcb is loose
short of
B: Console defective
display
TREADMILL MAINTENANCE
Proper maintenance is very important to ensure a faultless and operational condition of the
treadmill. Improper maintenance can cause damage to the treadmill or shorten the life of the
Change the transformer
Change the controller
Change the motor wire or change the
motor
properly connect the wire or change
the controller
Re-connect the speed sensor
Change the speed sensor
properly connect the wire ,
Change the controller
Change the controller
Change the motor
Check the safety key is in place.
wire did not properly connect the wire or change
the wire
Change the console
Tight the screw
Change the console
82