Techness RUN 200 TOUCH Mode D'emploi page 81

Trouble Shooting
Problem
Treadmill does not work
Belt does not run properly
Belt is slipping
ERROR MESSAGE AND SOLUTION:
Problem
A : Did not connect the power
supply
B: Safety key not in place
Treadmill
doesn't work
C: transformer faulty
D: electro circuit interrupted
Treadmill
A :safety key fallen off
stops
B: the electronic system has a
suddenly
problem
Safety Key is damaged
Safety Key
defective
Key will not work
A: Console wire loose or faulty
E1
B: computer defective
Possible cause
a. power supply disconnected
b. safety key disconnected
c .console cable disconnected
d. treadmill is not switched on
a .running belt not lubricated enough
b. belt too tight
a. belt is too loose
b .Motor belt is too loose
Reason
Plug into socket
Insert safety key
Check console and signal cable
Switch on
Use silicon oil on running board
Adjust running belt
Adjust running belt
Adjust the motor belt
How to settle the problem
Connect the power supply
Well put the safety key on the correct
position
Replace or repair transformer
Check the connection wire is in place
correctly.
Properly attach the safety key.
Phone/email for the after sale service
Change safety key
Change key input board, Change pcb
board or Change computer.
properly connect the wire or Change
the wire
Change the computer
81
Corrective action