Before The First Use; Installing The Charging Station - Linea 2000 DOMO Série Mode D'emploi

BEFORE THE FIRST USE

· Put two AAA batteries in the remote control. Set the time (see "use with remote control/
CLK: clock")
· Prior to initial use, charge the robot vacuum cleaner for 12 hours.
· Place the signed brushes on the vacuum cleaner. Press on them until you hear a click. The
brushes and the machine are marked with L (left) and R (right); make sure they match.

INSTALLING THE CHARGING STATION

1. Place the charging station on a smooth hard surface,
e.g. tiles, parquet, short-haired sturdy carpet,
against a wall or cupboard.
2. Make sure that there is an area of at least 1 m free
on the left and right sides of the charging station.
In front of the charging station, there must be a
free area of 2 m (Fig. 1). If this is not the case, it is
possible that the vacuum cleaner cannot find the
charger when it must charge.
3. Take the adapter, put the plug in the outlet and put
the DC plug into the charging station (Fig. 2).
IMPORTANT: always make sure that no cables are in front
of or next to the charging station; these could get caught
between the wheels or brushes of the vacuum cleaner.
USE
Turn the machine on with the on switch on the side of the appliance prior to use or charging.
STANDBY/SLEEP MODE/OFF
Standby
The machine is in standby mode when the on switch is on and the machine is in idle state,
ready to be used immediately.
Sleep mode
When the machine is in sleep mode, you must first activate it before you can start the
machine. This is done by pressing the on/off touchscreen button on the machine or with the
ON/OFF button on the remote control.
The machine automatically goes into sleep mode after being in standby mode for 15 minutes.
You can also turn on the mode yourself by pressing and holding the on/off touchscreen button
on the machine for 3 seconds.
40
DO7288S
Fig. 1
Fig. 2