Sprayer Setup - Homeright Pro 5.0 Mode D'emploi

Sprayer Setup

1
Use the correct spray tip for the material being
sprayed. (See page 10.) Check spray tip and
atomized valve for wear before each use. Insert
atomizer valve and securely screw on spray tip.
4
Insert pick-up tube into cylinder housing.
Using the Optional
Flexible Extension
The flexible extension can be
bent at any angle to make
spraying hard to reach areas
easier to spray. Using the
flexible extension will prevent
tilting the sprayer.
When using the flexible
extension, two atomizer
valves must be used. The
longer atomizer valve must be
between the cylinder housing
and flexible extension, and the
shorter atomizer valve must be
between the flexible extension
and spray tip.
English
8
C820425D.f_MAN_Pro50-55_EN-FR-ES.indd 8
2
Remove container and pick-up tube.
5
Fill container with paint/stain, and thin if
needed. We recommend thinning exterior latex
paint 5-8%. About 6-10 oz per gallon.
7
Long
Atomizer
Short
Atomizer
Attach flexible extension between cylinder
housing and spray tip. The flexible extension
uses its own atomizer valve as well as the
longer atomizer valve. Flexible extension is not
necessary when using suction tube.
3
Squeeze a small amount of oil (included,
3-in-One oil or similar) into the pick-up tube
®
port and the return port. Plug in sprayer and
squeeze trigger 3-5 seconds to lubricate piston
with oil.
6
Screw container to cylinder housing and plug
in sprayer.
8
Bend the flexible extension as required for
the project. Use the suction tube to paint at
any angle, straight up or straight down, great
for floors and ceilings. See page 11 for more
information.
www.homeright.com
8/15/11 10:41 AM