Intended Use; Saw Blades; Specifications; Parts Of The Machine - Festool KAPEX Manuel D'utilisation Original

The risk from these exposures varies, depend­
ing on how often you do this type of work. To re­
duce your exposure to these chemicals: work in
a well ventilated area, and work with approved
safety equipment, such as dust masks that are
specially designed to filter out microscopic par­
ticles. Wash hands after handling.
WARNING
TO REDUCE THE RISK OF INJURY, USER
MUST READ INSTRUCTION MANUAL.
4

Intended use

The power tool is a stationary unit designed for
sawing blocks of wood, plastic and similar ma­
terials. Do not use it to process other materials,
in particular steel, concrete and mineral mate­
rials.
When fitted with the special saw blades offered
by Festool, the machines can also be used for
sawing unhardened ferrous metal and non-fer­
rous metal.
This power tool may only be used by experts or
instructed persons.
The user is liable for improper or non-in­
tended use.
4.1

Saw blades

The saw blades must comply with the following
data:
– Saw blade diameter 10-1/4" (260 mm)
– Cutting width 3/32" (2.5 mm) (corresponds
to the tooth width)
– Locating bore 1-3/16" (30 mm)
– Standard blade thickness 1/16" (1.8 mm)
– Saw blade in accordance with EN 847-1
– Saw blade with chip angle ≤ 0°
Festool saw blades comply with EN 847-1.
Only saw materials for which the saw blade in
question has been designed.
5

Specifications

Mitre saw
Performance
Speed (idle)
Tool spindle dia.
KS 120 REB
13 A
1400–3600 rpm
1-3/16" (30 mm)
Mitre saw
Weight according to
EPTA-Procedure
01:2014
For maximum workpiece dimensions see the
section on Working with the power tool.
6

Parts of the machine

[1.1] Handle
[1.2] On/off switch
[1.3]
Safety lock
[1.4] Cutting depth limiter lever
[1.5]
Rotary knob for clamping the pulling
unit
[1.6] Transport lock
[1.7]
Scale for mitre angle (vertical)
[1.8] Extension table
[1.9]
Rotary knob for extension table
[1.10] Scale for mitre angle (horizontal)
[1.11] Clamping lever for mitre angle (hori­
zontal)
[1.12] Notch lever for preset mitre angle
(horizontal)
[1.13] Pendulum guard
[1.14] Rotary handle for precision adjust­
ment of mitre angle (vertical)
[2.1]
On/off switch for laser
[2.2] Speed adjusting wheel
[2.3]
FastFix spindle stop
[2.4] Clamping lever for stop ruler
[2.5] Bevel holder
[2.6] Release lever for special cutting posi­
tion
[2.7]
Lever for special cutting position
[2.8] Cable winder with integral carry han­
dle
[2.9]
Clamping lever for mitre angle (verti­
cal)
[2.10] Selector switch for mitre angle range
(vertical)
The pictures for the functional description are
on a fold-out page at the beginning of the in­
struction manual. While reading the manual
English
KS 120 REB
52 lb. (24 kg)
11