Settings; Tool Replacement - Festool KAPEX Manuel D'utilisation Original

English
8

Settings

WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
Replace the adhesive warning label [6.1] for the
laser with the label in your language that is en­
closed with the tool.
6.1
8.1 Selecting the saw blade
Festool saw blades are identified by a coloured
ring. The colour of the ring represents the ma­
terial for which the saw blade is suited.
Colour Material
Yellow Wood
Red Laminated wooden pan­
els
Green Eternit fibre cement
panels
Blue Aluminium, plastic
8.2

Tool replacement

WARNING
Risk of injury
► Observe the following instructions:
14
R R
L L
6
Symbol
7.1 7.2 7.3
7.4
7.5
– Disconnect the mains plug from the socket
before changing tools.
– Only use the spindle stop [7.2] when the
saw blade is at a standstill.
– The saw blade becomes very hot during op­
eration; do not touch it before it has cooled
down.
– Wear protective gloves due to the risk of in­
jury from sharp blades while changing
tools.
Removing the saw blade
► Move the machine into the working position.
► Press the spindle stop [7.2] and turn it
clockwise by 90°.
► Fully loosen the screw [7.8] using the hex
key [7.9] (left-hand thread).
► Press the on/off switch [7.3] and open the
lock of the pendulum guard.
► Fully open the pendulum guard [7.4].
► Remove the clamping flange [7.7] and the
saw blade.
Fitting the saw blade
► Clean all parts before installing them (saw
blade, flange, screw).
► Place the saw blade on the tool spin­
dle [7.5].
WARNING
Risk of injury
► Make sure that the rotational directions
of the saw blade [7.6] and the ma­
chine [7.1] correspond to each other.
► Secure the saw blade with the flange [7.7]
and the screw [7.8].
► Firmly tighten the screw [7.8] (left-hand
thread).
► Press the spindle stop [7.2] and turn it anti-
clockwise by 90°.
7
7.6
7.7
7.8
7.9