8.3
Workpiece clamp
8.2
8
Fitting the workpiece clamp
► Fit the workpiece clamp [8.1] into one of the
two holes [8.2]. The clamping unit must
point towards the rear.
► Twist the workpiece clamp so that the
clamping unit faces forward.
8.4
Dust extraction
WARNING
Health hazard posed by dust
► Always work with an extractor.
► Only use a dust extractor designed to col
lect the specific type of dust and particles
from the material being cut.
► Follow OSHA and NFPA regulations to en
sure a safe work environment.
9.1
9a
A Festool dust extractor with an extractor hose
diameter of 1-7/16" or 1-16" (36 mm or 27 mm).
8.1
9.2
(1-7/16" (36 mm) recommended due to the re
duced risk of clogging) can be connected to the
extractor connector [9.1].
The flexible chip deflector [9.2] improves the
collection of dust and chips. Therefore, never
work without a fitted chip deflector.
9b
The chip deflector is clamped in position on the
guard with the clamp [9.3]. For this, the
hooks [9.4] of the clamp must lock into the re
cesses [9.5] of the guard.
8.5
Adjusting the table extension
► Open the rotary knob [1.9].
► Pull out the table extension [1.8] far enough
that the workpiece is laid out fully.
► Close the rotary knob.
If, despite the table extension being ex
tended as far as possible, the workpiece
protrudes over the table, the workpiece
must be supported by other means.
8.6
Workpiece stop
10.1
10
Adjusting the stop ruler
For mitre cuts, you must adjust the stop rul
ers [10.1] so that they do not impede the func
tionality of the pendulum guard or come into
contact with the saw blade.
English
9.3
9.4
9.5
10.2
10.3
15