Intended Use; General Safety Instructions - Festool ZS-OF 2200 Guide D'utilisation

Table of contents
Symbols
Scope of delivery

Intended use

General safety instructions

Routing with the edge guide
Template routing
Routing with a guide rail system FS
Changing the sub base
The specifi ed illustrations are at the beginning of
the Operating Instructions.
Symbols
Warning of general danger
Read the operating instructions/notes
Scope of delivery
[1.1] Sub base LA-OF 2200 D36 CT
[1.2] Support AFB-OF 2200
[1.3] Sub base LA-OF 2200 D36
[1.4] Template guide
KR-D 1/2'' / 12,7 / OF 2200
[1.5] Template guide
KR-D 3/4'' / 19,05 / OF 2200
[1.6] Template guide
KR-D 1'' / 25,4 /OF 2200
[1.7] Template guide
KR-D 1_3/8'' 34,92 / OF 2200
[1.8] Edge guide SA-OF 2200 with extraction
hood
[1.9] Guide rods ST-OF 2200
[1.10] Guide rail attachment FS-OF 2200 with
sub base
Intended use
The accessories are designed for router OF 2200
and should be used only for the applications speci-
fi ed in these instructions.
The user bears the responsibility for damage and
accidents caused by improper use.
General safety instructions
Before using the accessories, care-
fully read these instructions and the instructions
for the OF 2200 all the way through.
Keep all of the attached documents
and pass on the documentation if the machine
changes ownership.
Routing with the edge guide
The edge guide is positioned parallel to the work-
piece edge.
– Secure both guide rods [2.4] with the two rotary
knobs [2.2] on the edge guide.
– Insert the guide rods into the grooves on the
router base to the required distance and secure
them by turning the rotary knob [2.1].
Fine adjustment
– Unscrew the rotary knob [2.7] to make fi ne
adjustments with the adjusting wheel [2.5].
The dial ring [2.6] has a 0.1 mm scale for this
purpose. If the adjusting wheel is held secure,
the dial ring can be turned separately and set to
"Zero". The millimetre scale [2.3] on the main
casing is useful for making larger adjustments.
– Tighten the rotary knob [2.7] again after com-
pleting any fi ne adjustments.
– Adjust both guidance jaws [3.3] so that they are
approx. 5 mm from the router bit. To do this,
loosen screws [3.2] and tighten again after
completing the adjustments.
– Only when routing along an edge: slide the ex-
tractor hood [3.1] until it latches into position on
the edge guide and connect an extraction hose
27 mm or 36 mm in diameter to the extractor
connector [3.4]. Alternatively, let the machine
to extract the dust via the extractor connector.
Template routing
When routing with templates, fi t an integrated
template guide to the router.
 Template guides can be used in combination
with the standard sub base. Special sub bases
are available to improve the support surface
(see sticker on lid).
An excessively large routing tool may
damage the template guide and cause accidents.
Make sure that the routing tool used fi ts through
the opening on the template guide.
4