Intended Use; Functional Description; Electronics - Festool DOMINO XL DF 700 EQ Guide D'utilisation

The machine is intended to create DOMINO dowel
connections in hard and soft wood, chipboard, ply-
The pictures for the functional description are on a
fold-out page at the beginning of the instruction
manual. When reading of the manual you can fold
out this page for having always an overview of the
machine.
[1-1] Rubber buffer
[1-2] Stop pins
[1-3] Handles
[1-4] On/Off switch
[1-5] Display for dowel hole width
[1-6] Adjusting lever for dowel hole width
[1-7] Slide for routing depth adjustment
The machine features full-wave electronics with
the following features:
Smooth start-up
The electronically controlled smooth start-up en-
sures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through elec-
tronic control to ensure a uniform cutting speed
even when under load.
Temperature cut-out
The machine power supply is limited and the speed
reduced if the motor exceeds a certain tempera-
ture. The machine continues operating at reduced
power to allow the ventilator to cool the motor
quickly. If the machine temperature exceeds the
maximum permitted value for longer periods, the
machine switches off completely after approx. 40

Intended use

wood and fibreboard. All applications beyond this
are regarded as unintended use.
The machine is designed and approved for use by
trained persons or specialists only.

Functional description

[1-8]
[1-9]
[1-10] Unlocking of motor unit/guide frame
[1-11] Selection slide for routing height adjustment
[1-12] Clamp lever for routing angle adjustment
[1-13] Button for releasing stop pins
[1-14] Clamp lever for routing height adjustment
[1-15] Extractor connector
[1-16] Spindle lock
[1-17] Mains power cable

Electronics

seconds and can only be switched on again once the
motor has cooled sufficiently.
Restart protection
The integral restart protection prevents the ma-
chine from automatically starting up again after an
interruption in power when the machine is used in
continuous operating mode. In this case the ma-
chine must be switched off and then switched back
on again.
The user bears the responsibility for damage
and accidents caused by improper use.
Snap button for routing depth adjustment
Marker for routing depth adjustment
9