CAME BKV15AGE Manuel D'installation page 70

Gate-open warning light
It signals the gate status.
Configuration
Manage lights
Light E3
Choose the operating mode of the lighting device connected to the output.
Configuration
Manage lights
Courtesy time
Set the lighting device operation time.
Configuration
Manage lights
Pre-flashing time
Set the time for which the beacon is activated before each manoeuvre.
Configuration
Manage lights
RSE1
Configure the function to be performed by the card inserted in the RSE1 connector.
If an RSE card – configured for paired connections – is plugged into the RSE_1 connector, use the RSE_2 connector for remote connection (CRP). In this
case, a CAME KEY cannot be connected.
Configuration
RSE communication
CRP address
Assign a unique identification code (CRP address) to the control board. It is used where there are multiple operators connected via CRP.
Configuration
RSE communication
Gate-open warning light
Light E3
Courtesy time
Pre-flashing time
RSE1
CRP address
Warning light on (Default) - The warning light stays on when the gate is moving or
open.
Warning light flashing - The warning light flashes when the gate is moving and it stays
on when the gate is open.
Rhythmic flashing - Every hour, 3 + 3 flashes signal that the number of operations for
maintenance has been reached.
Deactivated (Default)
Cycle lamp
The light remains off if an automatic closing time is not set.
Courtesy light
The light remains on for the time set under the function [Courtesy time].
60 to 180 seconds (Default 60 seconds)
Deactivated (Default)
From 1 to 10 seconds
CRP (Default)
Paired
Off
1 to 254