Operation - oventrop Unibox RTL Notice D'utilisation

Unibox RTL
fitting the cover. This ensures that the
handwheel and the thermostat are in the
correct position. The sensor unit is factory
calibrated (see section 12.4 on page 39).
Please make sure that the broad lo-
cating groove inside the handwheel
is at the top or at the position of
the temperature scale shown in
illustr. 14.
Illust. 14: Locating groove at the handwheel
(1) Locating groove
3. Fit the cover with the integrated handwheel
to the Unibox RTL.
102273580-V4.06.2020
1
Illust. 15: Fitting of the cover with handwheel
8.

Operation

Set the fluid temperature of the surface tem-
perature regulation circuit at the handwheel
(see section 3.4.1 on page 29). Surface
temperature regulation is affected by the local
conditions (such as tile thickness).
Operation
35