Troubleshooting Table - Cinderella GAS Manuel De L'utilisateur

8.3 TROUBLESHOOTING TABLE

Error
Message
Empty the ash
Ash container
should be emptied
Ash containermust
Toilet locked
be emptied, toilet
container full
locked.
Ash container Ash container is
out of position
Ventilation fan Error main fan
Burner fan Error burner fan Flashing Flashing Flashing
Hatch/bowl liner is
jammed mechanism
Heating circuit Error burner
interrupted
Toilet lid opens.
Thermocouple is
faulty
Bad combustion
and/or odours
Unreadable- or no
display message
visible
20
Red Yellow
Display
LED
Flashing Flashing
container
alternating alternating
Constant Constant Constant
Flashing Flashing
Flashing
Error hatch Flashing
Flashing
system
Lid is open Flashing
Error temp. Flashing
sensor
Green
Sound
LED LED
3 beeps
Constant
3 beep
every 10
seconds
Constant 3 beeps
Flashing 10 beeps
10 beeps
Constant 10 beeps
Constant Constant
Constant
Flashing Constant
What to Do
1 Remove and empty ash container.
1 Remove and empty ash container.
1 Adjust the position of the ash container.
Check the stop pin on the ash container.
2
Visually check the condition of the magnet
3
on the ash container.
4
If problem persists, call for service.
1
Check fan for obstructions.
2
Reset toilet.
Open and close toilet lid.
3
Start incineration.
4
If error persists, disconnect plug and call for service.
5
1
Reset the toilet
Open and close the lid.
2
Start incineration by pushing the start button
3
If problem persists, call for service.
4
1 When toilet is hot: Reset toilet.
Open and close lid before pressing the Start
2
button.
3 If unsuccessful, reset toilet, insert liner, pour in 3
cups of water and press the Start button. If still
4 unsuccessful, wait until toilet has cooled (fan
stopped). Try to remove paper/liner manually.
If problem persists, call for service.
5
Reset the toilet and wait 15 minutes.
1
Check temperature safety on right hand side of
2
toilet. 'Unscrew grey plug' and 'push' on fuse in-
side with finger, do not use any sharp objects.
If the fuse was triggered, you will hear a click. If
so, check inlet/outlet air.
If the fuse was not the problem, call for service.
3
1 Close toilet lid.
2
If problem persists, call for service.
1 Reset toilet.
Open and close lid.
2
Start incineration.
3
If error persists, unplug the toilet and call for
4
service.
1
Perform maintenance described on page
10–13. Check that the installation is correct
as described in the installation manual.
If problem persists, call for service.
2
1
Reset the toilet.
If problem persists, call for service.
2