Steam-Cleaning The Exhuast Vent; Cleaning The Bowl - Cinderella GAS Manuel De L'utilisateur

NB!
• Do not use any sharp tools or objects when cleaning the ash container insert, as this will damage the insert
and reduce its service life.
• The remaining ash is sterile and safe to handle when it has burned to a light colour. If the ash is black and
flaky or the incineration cycle was incomplete, run an extra incineration cycle to ensure that the ash has been
fully incinerated. If the problem persists, see the troubleshooting section for further advice.
• The ash is not suitable to use as fertilizer or compost. It should be disposed of in your household waste in
accordance with relevant public regulations.

7.1.2 STEAM-CLEANING THE EXHUAST VENT

Recommended frequency: After every one hundred uses or when emptying the ash container
1. Ensure that the toilet is cold and the ash container has been emptied and cleaned.
2. Lift the toilet lid.
3. Press and hold the Start button for three seconds to open the hatch to the washing position.
4. Pour approximately 1/4 gallon (1 litre) of clean water into the toilet.
(Note: It may be convenient to clean the bowl at this point. See steps below.)
5. Close the toilet lid and press Start to begin an incineration cycle. The water will start to boil and the steam
will clean the exhaust system.

7.1.3 CLEANING THE BOWL

Recommended frequency: As required for cleanliness and when emptying the ash container.
1. Open the toilet lid.
2. Press and hold the Start button for three seconds to open the hatch to the washing position.
3. Use moist paper, water and a mild cleaning agent as required.
4. Close the toilet lid and press Start to begin the incineration cycle.
WARNING!
Do not use flammable cleaning agents to clean the bowl.
NB!
Do not use chlorine-based cleaning agents to clean the bowl. Chlorine is extremely harmful for the catalyst,
and if put into the toilet it may cause the catalyst to malfunction.
15