Italtecnica Brio TOP Manuel D'instructions page 25

LINE CONNECTION
The device power supply is single phase at 230 Volt 50/60Hz. The electrical system to which the device
is connected must comply with current standa rds and must therefore be fitted with:
- automatic thermal magnetic circuit breaker with high breaking power and trip current in proportion to
the power of the pump installed
- earthing connection with total resistance in conformity with local standards and in any event no more
than 100 .
If the device is used in swimming pools, fountains, or ga rden ponds, a residual current circuit breaker
type "A" must be installed, with I∆n=30mA
If the device is not equipped with a power cable and plug, install another device that ensures omnipolar
disconnection from the mains with a contact opening gap of at least 3 mm.
If the terminals supplied are not used, the faston terminals must be crimped by specialist personnel using
special pliers.
The recommended cable section is 1.5mm
The type of electric cable must correspond to the conditions of use (use in domestic rooms, dry or wet, for
installation indoors or outdoors).
ELECTRIC PUMP CONNECTION
use (use in domestic rooms, dry or wet, for installation indoors or outdoors).
Also observe the installation limits as declared by the manufacturer of the electric pump connected to
Brio Top.
CAUTION:
- all electrical connections must be made by speci alised personnel
- i ncorrect connections of the electric motor can cause damage to the device or the pump motor
itself.
- failure to observe the i nstructions in this section can cause serious damage and/or physical i njury
and releases the manufacturer from all liability.
- i n the event of damage to the power cable or the cable between Brio Top and the electric pump, it
must be replaced exclusi vel y by the devi ce manufacturer or assigned and suitably quali fied
personnel, to prevent risks to objects and persons.
2
, compatible with electric pumps up to 16A.
Brio Top can be installed on single phase pumps with 230Vac
power supply, already fitted with capacitor. Therefore at the
time of electrical connections, ensure that the terminals in the
electrical compartment of the motor are connected a ccording to
the instructions of the electric pump manufa cturer. The figure
alongside shows a typical example of connection.
If the terminals supplied are not used, the faston terminals
must be crimped by specialist personnel using special pliers.
The recommended cable section is 1.5mm2.
The type of electric cable must correspond to the conditions of
ГК Водная техника info@water-technics.ru (495) 771 72 72 www.water-technics.ru
Интернет-магазин info@wtpump.ru (499) 937 50 61 (800) 505 78 67 www.wtpump.ru
25