Commissioning; Removing The Car Body; Installing The Receiver Aerial Cable; Inserting The Driving Battery In The Vehicle - Reely ROAD 4WD RtR Notice D'emploi



9. Commissioning

a) Removing the Car Body
The car body is secured with fastening clamps that must be pulled from the holding pins. Then the car body can be
lifted off to the top (if required, remove the rear spoiler first. It is also secured with fastening lamps).
b) Installing the Receiver Aerial Cable
The receiver's aerial cable is normally rolled up on delivery. Unwrap the aerial cable completely and smoothen it
carefully. For this, hold the aerial cable near the receiver with two fingers (do not hold the receiver but the cable) and
then pull the cable straight repeatedly with two fingers of your other hand.
Now insert the aerial cable from below through the attachment (possibly already performed by the manufacturer).
Guide it through the aerial tube and plug the aerial tube into the respective attachment mount on the vehicle. Simply let
excess aerial cable protrude loosely from the tip of the aerial tube.
If a rubber cap for the aerial tube is enclosed, it prevents the dislocation of the aerial cable after it is attached to the tip.
Make sure that the aerial cable does not protrude into the drive or touch the cardan shaft! It is normally
sufficient to slightly tighten the cable or fix it in place with a cable binder.
Never shorten the aerial cable! Never roll up the aerial cable! This reduces the range extremely.
c) Inserting the Driving Battery in the Vehicle
Pull off the two safety clips on the retainer of the battery pack and then lift the retainer upwards from the vehicle.
Insert the driving battery into the chassis; the connection cable should point towards the rear axis to not hinder the
steering mechanics.
Reinsert the attachment strut in the right orientation and reattach it with the previously removed safety clips.
Attention!
The drive battery must not be connected to the speed controller yet.
40