Reely ROAD 4WD RtR Notice D'emploi page 58

The vehicle doesn't drive in a straight line correctly
• Adjust straight driving using the trimmer "ST.TRIM" (see chapter 8, figure 1, item 7) at the transmitter.
• Check the steering rods or wheel alignment setting.
• Did your car have an accident? If so, check the vehicle for any defective or broken parts and replace them.
Steering or driving motions opposite to movement of steering wheel and transmitter throttle/brake lever
• Put the reverse switch for steering ("ST.REV", chapter 8, figure 1, item 9) and drive ("TH.REV", item 10) at the
transmitter in the right position.
• If the brushless motor is disconnected from the speed controller and wasn't reconnected, the alignment of the 3
connection cables is not correct. Simply swap two of the three cables between motor and speed controller. This will
reverse the rotational direction of the brushless motor.
58