Commissioning - Reely ROAD Carbon Fighter III Notice D'emploi

b) Commissioning
The manual for the remote control system is included separately. Always observe all safety information
included in it as well as any other information!
Always commission the vehicle according to the following sequence. Otherwise, unpredictable reactions of the vehicle
may result! Also observe chapter 8.
Step 1:
Switch on the transmitter if you haven't done so already. Check its function (e.g. operation display of the transmitter).
Step 2:
Place the vehicle on an appropriate surface so that the wheels can move freely.
Connect the receiver power supply and put the on/off switch for the receiver power supply in the „ON" position (=
switched on).
Step 3:
Before operating the vehicle, check whether the stationary model reacts as expected to the commands of the remote
control (throttle and steering servo).
Step 4:
Set the trimming for throttle/brake at the transmitter so that the brake will not catch when the lever (neutral position
of the throttle/brake lever at the transmitter) is released entirely.
Step 5:
Set the trim for steering so that the front wheels are about straight. The exact setting for straight driving can be
performed during a drive.
Step 6:
Check the throttle and steering servo for whether they run „to block" in operation mechanically at the corresponding
full deflection at the transmitter. In this case, the servo path at the transmitter must be adjusted accordingly (see
operating instructions of the remote control).
Step 7:
Programme a failsafe function on the throttle servo (if integrated in the remote control) and check it for correct
function. If this function is not integrated into the remote control, we urgently recommend using a failsafe module
(must be purchased separately.
38