Oil Air Filter And Fuel Vehicle; Attaching And Fastening The Car Body And Rear Wing; Checking The Range Of The Remote Control - Reely ROAD Carbon Fighter III Notice D'emploi

f) Oil Air Filter and Fuel Vehicle
Oil the air filter slightly in order to filter out dust particles. Use special air filter oil for this (not included in the delivery).
Screw on the air filter housing off of the front of the filter with the central screw and on again after oiling. Observe
correct fit of the filter and its holder.
If the air filter is not oiled, small dust particles are sucked in and lead to a strongly increased wear of the
motor. At continuous motor operation without oiled air filter, motor damage may occur; loss of warranty/
guarantee!
Open the tank lid and fill the tank with a two-stroke mixture (mixing ratio 1:25). Use only high-quality synthetic two-
stroke oil and Super fuel (Super Plus) for the mixture.
Two-stroke mixture with „E10" fuel or a mixture with a lower oil share must not be used. Motor damage
threatens at non-observance; loss of guarantee/warranty!
To avoid having to remove the car body each time you fuel up the car, we recommend that you cut a
matching opening into the car body at the right position (if you have not done so yet).
g) Attaching and Fastening the Car Body and Rear Wing
Put the car body onto the supports reversed as described in chapter 8 a) and secure them each with safety clips.
Install the tail wings by pushing a sponge rubber ring and then the tail wing each at the left and right of the tail wing
holder. Secure the tail wing with two safety clips.
Your car is now ready for its first test run.
h) Checking the Range of the Remote Control
In order not to lose control over your model you should, before each first start or after a crash, check the function and
range of the RC system. For the range test, it is sufficient to check the steering servo function.
Due to the good traction of the wheels and the weight of the vehicle, the wheels would not follow your steering
commands spontaneously and directly while still on the floor. Therefore, support the model at the front axle in a way
that allows the wheels to hang freely.
Only perform the range test without the engine running!
• First switch on the transmitter (if you have not done so yet), then the receiver.
• Move approx. 50 m away from the model.
• Move the steering wheel at the transmitter (channel 1) to the right. Now the wheels must turn towards the right!.
• Move the steering wheel to the left. Now the wheels must turn towards the left.
• Release the lever of the remote control. The wheels must return to the straight position.
Never drive the model with a defective remote control!
Before driving, find the error if the reactions to the remote control during the range test are not as described.
44