EINHELL PE-ASK 18 Li Basic Mode D'emploi page 137

Loosen vise knob
S1 To set the required vise angle, loosen
the vise lock knob 11.
Caution! Make sure the appliance is
switched off and the battery is re-
moved.
Raise chain stopper
S3 Raise the chain stopper
chine vise 9.
Lower chain stopper
S5 Lower the chain stopper 6
saw chain to the right until a right cut-
ter is centric on the
chain to the left until the cutter engag-
es at the chain stopper 6.
Lock chain
S7 If the proper distance is set on the
chain stopper screw 5
counter nut.
Tighten the chain lock lever
the chain in place.
3 Insert a charged battery (not included)
into the battery slot 14
place.
To remove the battery, press its release
button and pull it out.
S2
6 of the ma- S4
and pull the S6
vise 9. Pull the saw
S8
lock it with the
7
to lock
until it clicks into
Set top plate angle / B
Set the desired top plate angle at the
vise angle scale 10. Tighten the vise
lock knob 11.
Insert chain
Insert the saw chain into the chain
bar 8. The rotation direction is from left
to right.
Caution! The saw chain is sharp,
make sure to wear protective gloves.
Lower grinding wheel
Carefully lower the grinding wheel
behind a right cutter. Use the chain
stopper screw 5 to set the required
distance between cutter and grinding
wheel 4.
Set cutting depth
With the grinding wheel still lowered,
set the required cutting depth on the
cutting depth screw 13 and lock it with
the counter nut.
4
EN 137