EINHELL PE-ASK 18 Li Basic Mode D'emploi page 136

Product overview
1 Handle
2 Machine head
3
Guard
4
Grinding wheel
5 Chain stopper screw
6 Chain stopper
7 Chain lock lever
8 Chain bar
9 Vise
10 Vise angle scale
11 Vise lock knob
12 ON/OFF Switch
13
Cutting depth screw
14
Battery slot
15 Machine base
16 Table mount
Intended use
The machine is intended for sharpening chain-
saw chains specified in technical data.
Any other use or modification to the machine
is considered as improper use and could
cause considerable dangers.
The tool is not intended for commercial use.
ASSEMBLY
1 Install the machine base
and stable work surface, using suitable
screws and washers (not included).
136 EN
Using the machine
1. Take the steps S1-S8.
2. Raise the machine head 2.
3. Turn the ON/OFF switch
switch on the tool.
4. Wait until the grinding wheel has reached
full speed.
5. Slowly lower the machine head
sharpen the first right cutter.
6. Raise the machine head 2.
7.
Loosen the chain lock
chain until the next right cutter appears
(every two cutters).
8. Pull the chain to the left against the chain
stopper
ver 7. Slowly lower the machine head
and sharpen the remaining right cutters
with this adjustment.
9. Once all right cutters are sharpened,
press the ON/OFF
switch the machine off.
10. To sharpen the left cutters, take the steps
S3-S8, but set the top plate angle B on
the vise in the opposite direction.
11. Take the steps 2.-9. from these instruc-
tions in order to sharpen the left cutters.
15 to a level 2 Install the
base 15, removing and reinstalling the
vise lock knob 11.
Caution! Make sure the grinding
wheel has a smooth round shape.
12
lever 7
6 and tighten the chain lock le-
switch 12
vise 9 to the machine
to I (on) to
2 and
and pull the
2
to 0 (off) to