Publicité
Les langues disponibles
Les langues disponibles
Disconnect tools
• When not in use, before servicing and when
cleaning accessories such as blades, bits
and cutters, disconnect tools from the pow-
er supply.
Remove adjusting keys and wrenches
• Form the habit of checking to see that keys
and adjusting wrenches are removed from
the tool before turning it on.
Avoid unintentional starting
• Ensure switch is in „off" position when
plugging in.
Use outdoor extension leads
• When the tool is used outdoors, use only ex-
tension cords intended for outdoor use and
so marked.
Stay alert
• Watch what your are doing, use common
sense and do not operate the tool when you
are tired.
Check damaged parts
• Check the tool and its protective equipment
prior to further use to determine that it will
operate properly and perform its intended
function.
• Check for alignment of moving parts, bind-
ing of moving parts, breakage of parts,
mounting and any other conditions that may
affect its operation.
• A guard or other part that is damaged
should be properly repaired or replaced by
an authorized service centre unless other-
wise indicated in this instruction manual.
• Have defective switches replaced by an au-
thorized service centre.
• Do not use the tool if the switch does not
turn it on and off.
Warning
• The use of any accessory or attachment
other than one recommended in this in-
struction manual may present a risk a per-
sonal injury.
Have your tool repaired by a qualified per-
son
• The electric tool complies with the relevant
safety rules. Repairs should only be carried
out by qualified persons using original spare
parts. Otherwise this may result in consid-
erable danger to the user.
SAFETY WARNINGS FOR CHAIN SHARPEN-
ERS
a) Make sure the speed indicated on the grind-
ing wheel is the same or faster, than the
rated speed of the tool.
b) Make sure that the dimensions of the grind-
ing wheel are identical to the rated dimen-
sions of the tool.
c) Grinding wheels must always be installed,
used and stored according to the instruc-
tions of the manufacturer.
d) Always check the grinding wheel before
use. Never use damaged, cracked or aged
grinding wheels.
e) Make sure to use the backing layers if they
are provided with the grinding wheel.
f) Make sure the grinding wheel is installed
according to the instructions.
g) Before using the tool, let the wheel run idle
for approx. 30 sec. Stop the tool immediate-
ly if the tool vibrates heavily or other faults
become apparent.
h) Do not use separate reducer sleeves or
adapters to make grinding wheels with
larger holes fit properly.
i) Ensure that the tool is securely fastened to a
workbench.
j) Take care that the sparks generated during
use do not cause any danger, e.g. by hitting
persons or igniting inflammable material.
k) The tool runs on after it has been switched
off. Wait for the complete stop of the grind-
ing wheel before leaving the tool.
l) Disconnect tool from mains supply.
Switch off and wait for the tool to come to
a complete standstill before leaving it un-
EN
131
Publicité
