Wilo Stratos Notice De Montage Et De Mise En Service page 62

English
5.2 Technical data
Wilo-Stratos-Z/-ZD
Emission
sound-pressure level
Residual current ΔI
Electromagnetic
compatibility
1)
Standard version
2)
Special version or supplementary equipment (additional charge)
3)
See following warning
CAUTION! Risk of injury and damage to property!
Non-approved fluids can damage the pump and also cause injury.
Comply strictly with the relevant safety data sheets and manufacturer's
data!
3)
• Observe the specifications of the manufacturer regarding the mixing
ratios.
3)
• Additives are to be mixed to the fluid on the pressure side of the pump,
even if this is contrary to the recommendations of the additive
manufacturer!
CAUTION! Risk of property damage!
When changing, refilling or replenishing the fluid with additives, there is a
risk of material damage caused by the increasing concentration of chemical
substances. The pump is to be flushed separately for a sufficient amount of
time to ensure the old fluid has been completely removed from the interior
of the pump.
The pump must be disconnected for pressure cycle flushing. Chemical flush-
ing measures are unsuitable for the pump, in this case the pump must be
removed from the system for the duration of cleaning.
56
Drinking water acc. to EC Drinking Water Directive. The
material selection of the pumps corresponds to the state of
the art with regard to the guidelines of the German Federal
Environmental Agency (UBA) which are referred to in the
Drinking Water Ordinance (TrinkwV). Chemical disinfect-
ants can result in damage to material.
< 54 dB(A)
(depending on the pump type)
≤ 3,5 mA (see also chapter 7.2)
Emitted interference in acc. with:
EN 61800-3:2004+A1:2012 / Residential (C1)
Interference resistance in acc. with
EN 61800-3:2004+A1:2012 / Industrial (C2)
WILO SE 04/2016