Samsung POWERbot SR1AM70 Serie Guide D'utilisation page 36

Troubleshooting
Symptom
The POWERbot is not
working at all.
The POWERbot has stopped
during cleaning.
Suction power is weak.
The POWERbot cannot find
the docking station.
The POWERbot suddenly
cleans diagonally.
Point cleaning is not working.
1_VR7000_EN_DJ68-00763C-02_USA.indd 36
fCheck if the emergency switch is on.
fCheck if all the icons are displayed on the display panel.
fCheck if the POWERbot's battery is depleted.
– When "Lo" is displayed, place the POWERbot on the docking
station to charge it.
– When the battery indicator blinks, manually place the POWERbot
on the docking station to charge. (Only SR1AM7010UW series)
fReplace the batteries (AAA type) if the remote control is not
working.
fWhen "Lo" is displayed on the display panel, place the POWERbot
on the docking station to charge it.
fWhen the battery indicator blinks, manually place the POWERbot
on the docking station to charge. (Only SR1AM7010UW series)
fWhen POWERbot is immobilized by an obstacle such as a cord,
threshold etc, pick it up and move it away from the obstacle.
– If any fabric or string is caught in a drive wheel, turn off the
emergency switch and remove the fabric or string before using it
again.
fIf the "Filter inspection indicator" is on, turn off the emergency
switch and clean the dustbin.
fWhen there's too much dust in the dustbin, suction power may get
weakened. Turn off the emergency switch and empty the dustbin.
fIf the intake (on bottom of POWERbot) is blocked by foreign matter,
turn off the emergency switch and remove foreign matter from the
intake.
fWhen noise suddenly increase, turn off the emergency switch and
empty the dustbin.
fCheck if there's a power failure or whether the power plug is
unplugged.
fRemove any obstacles around the docking station that may prevent
POWERbot from returning to the docking station.
fWhen there's foreign matter on the charge pins, charging can be
affected. Clean the foreign matter off the pins.
fCheck if the docking station is installed along the grain of wooden
floors or tiles.
fThe POWERbot may clean in a diagonal direction if it is moving
to another area using the shortest route. It may also move at a
diagonal if it made contact with an obstacles at that angle, if it was
charged at the docking station at an angle, or if the grain of the
wooden/tile floor skewed is in that direction.
fIf you point the red light directly at POWERbot, it may not move in
desired direction.
– Point the red light on the floor within 1.6 ft (0.5 m) of POWERbot.
✻ ✻ Do not use point cleaning in direct sunlight, under bright light, or
on dark floors.
ENGLISH-36
Checklist
2017-02-23 오전 12:27:04