Samsung POWERbot SR1AM70 Serie Guide D'utilisation page 13

Steps to take if recharging not occuring:
Check the installation status of the
docking station when:
fthe docking station is located in a place where
the POWERbot cannot easily access it.
fthe distance between the docking station and
POWERbot is over 20 ft (5 m).
– It may take a long time for POWERbot to
return to the docking station for recharging
1_VR7000_EN_DJ68-00763C-02_USA.indd 13
Automatic charging
Recharging
Low battery (Lo)
ENGLISH-13
1. SR1AM7010UW Series
If the battery indicator blinks at 0.4 sec. intervals,
the POWERbot will automatically return to the
docking station to be charged.
2. SR1AM7040W✴ / SR2AM70✴✴✴✴ Series
When the battery indicator blinks during cleaning,
the POWERbot will return to the docking station to
charge itself automatically.
You can command the POWERbot to
recharge at the docking station while it is in
cleaning.
Manually charge the POWERbot by placing
it on the docking station.
Manually charge the POWERbot when:
fthe docking station is located in a corner
fthe battery is fully exhausted
fthe POWERbot is immobilized by an obstacle
(furniture etc.)
fthe POWERbot can't climb a threshold near
the docking station (The maximum height of
a threshold the POWERbot can climb is about
0.6 in (1.5 cm)).
fwhen the battery indicator blinks and "Lo" is
displayed
fwhen the battery indicator blinks (Applicable to
SR1AM7010UW Series)
fwhen the POWERbot is set to the Spot clean or
Manual clean mode
2017-02-23 오전 12:26:53