Legende; 2.1 Safety Instructions; Conformity With Standards; Field Of Application - Eaton Crouse-hinds Série GHG 713 Mode D'emploi

2

Legende

Warning:
This symbol indicates a serious hazard.
Ignoring this warning can result in death or the destruction of the
installation.
Attention:
This symbol indicates a possible failure. Ignoring this warning can
lead to the total failure of the device, system or operation to which it
is connected.
Note:
This symbol stresses important information.
10
Empty enclosures GHG 713

2.1 Safety instructions

The requirements of the IEC/EN 60079-31 regarding excessive dust
deposits and temperature to be considered from the user.
These empty enclosures may not be used in hazardous areas
without full certification. Even if they are fully certified, they are not
suitable for use in Zone 0 and Zone 20.
After apparatus has been installed in the empty enclosure, it shall be
tested and fully certified by a testing authority or authorized person.
They shall be used for their intended purpose and in perfect and
clean condition.
Prior to being put into operation, the apparatus shall be checked in
accordance with the instructions as per section 6.
The national safety rules and regulations for the prevention of
accidents, as well as the safety instructions included in these
operating instructions, that, like this text, are set in italics, shall be
observed!
3
They have been designed, manufactured and tested according to the
state of the art and to DIN EN ISO 9001:2015 and
EN ISO/IEC 80079-34:2011.
They are conform to the standards specified in the EC-Declaration of
conformity, enclosed separately.
4
Fully certified empty enclosures that have been tested by a testing author-
ity or authorized person are suited for use in hazardous areas in Zone 1/2
and Zone 21/22 in accordance with IEC/EN60079-10-1 and
IEC/EN60079-10-2.
The enclosure materials used, including any external metal parts, are
high quality materials which ensure a corrosion protection and resistance
to chemical substances corresponding to the requirements in a "normal
industrial atmosphere":
In case of use in an extremely aggressive atmosphere, you can obtain
information concerning the chemical resistance of the materials used
from your Cooper Crouse-Hinds branch.
The operations shall be carried out
by engineering/development specialists according to
IEC/EN 60079-0 and specialist companies with QM-system.

Conformity with standards

Field of application

- Aluminum
GB