Anslut 019884 Mode D'emploi page 21

5. Connect the live wire L (brown), neutral wire N (blue) and
earth wire (yellow/green).
6. Fit the cable grommet.
7. Connect the power supply.
NOTE:
• The product is only intended to be mounted on a wall.
• The installation height must be 2.3 – 3 m.
REMOVAL
1. Undo the 4 screws on the back.
FIG. 1
2. Remove the glass and reflector.
The glass is not glued for 10 W and 20 W.
FIG. 2
The glass is glued on the casing for 30 W and 50 W.
To remove the glass, put tape on the glass to protect it if
it breaks and warm with a hair dryer to soften the glue.
Carefully remove the glass with a knife. Remove the reflector.
FIG. 3
3. Remove the 2 screws for the LED module.
FIG. 4
4. Cut the wires and remove the LED module.
FIG. 5
EN
21