Publicité
Les langues disponibles
Les langues disponibles
4. Set the stop frequency.
Press Stop Freq and set the value to 5 kHz using the numeric keypad or the knob and arrows.
At this point, the instrument outputs a continuous sweep from 50 Hz to 5 kHz if output is enabled.
You can also set the sweep frequency boundaries of the sweep using a center frequency and frequency span. These
parameters are similar to the start frequency and stop frequency (above) and they provide added flexibility. To
achieve the same results, set the center frequency to 2.525 kHz and the frequency span to 4.950 kHz.
To generate a frequency sweep, press [Trigger] > Source
Manual
to put the trigger in manual mode. Press [Trigger]
to send a trigger. For more information, see
Trigger a Sweep or
Burst.
64
Keysight EDU33210 Series User's Guide
Publicité
