Publicité
Les langues disponibles
Les langues disponibles
Output a DC Voltage
You can output a constant DC voltage, from -5 V to +5 V into 50 Ω, or -10 V to +10 V into a high impedance load.
1. Press [Waveform] > MORE 1 / 2 > DC > Offset. The Offset value becomes selected.
2. Enter the desired voltage offset. Enter 1.0 with the numeric keypad or knob, and press the V softkey if you used the
keypad.
Set Duty Cycle of a Square Wave
The power-on default for square wave duty cycle is 50%. The duty cycle is limited by the minimum pulse width
specification of 16 ns. The following procedure changes the duty cycle to 75%.
Keysight EDU33210 Series User's Guide
31
Publicité
