Publicité
Les langues disponibles
Les langues disponibles
When shipped, DHCP is on, which may enable communication over LAN. The acronym DHCP stands for Dynamic
Host Configuration Protocol, a protocol for assigning dynamic IP addresses to devices on a network. With dynamic
addressing, a device can have a different IP address every time it connects to the network.
Some LAN settings require you to cycle instrument power to activate them. The instrument briefly displays a
message when this is the case, so watch the screen closely as you change LAN settings.
After changing the LAN settings, you must save the changes. Press Apply to save the setting. If you do not save the
setting, exiting the I/O Config menu will also prompt you to press Yes to save the LAN setting or No to exit without
saving. Selecting Yes cycles power to the instrument and activates the settings. LAN settings are non-volatile; they
will not be changed by power cycling or *RST. If you do not want to save your changes, press No to cancel all
changes.
View the LAN Settings
Press [System] > I/O Config to view the LAN Settings.
The LAN status may be different from the front panel configuration menu settings - depending on the configuration
of the network. If the settings are different, it is because the network has automatically assigned its own settings.
Press LAN Settings to access the LAN Settings Menu. See
Press LAN Reset restore the LAN settings to default values.
Keysight EDU33210 Series User's Guide
Modify the LAN Settings
for more details.
41
Publicité
