Before Using For The First Time - Siemens TE515 Série Mode D'emploi

en
The aromaDouble Shot function is activated
with the following settings:
Before using for
the first time
General
Fill the appropriate container using only
pure, cold, uncarbonated water and only
roasted beans (preferably espresso or
coffee bean blends for fully automatic coffee
machines)� Do not use coffee beans that
have been glazed, caramelised or treated
with other additives containing sugar, since
they will block the brewing unit�
The water hardness setting can be adjusted
on this appliance� The factory default setting
for the water hardness is 4� Check the
water hardness with the enclosed test strip�
If the check reveals a value other than 4,
change the setting on the appliance accord-
ingly after switching on (see "Menu settings"
Water hardness)�
Switching on the appliance
● Remove the protective film.
● Place the fully automatic espresso
machine on a flat, water­resistant surface
that can take its weight� Make sure that
the machine's ventilation slots remain
unobstructured�
Important: Only use the appliance in
frost­free rooms. If the appliance has been
transported or stored at temperatures below
0 °C, wait at least 3 hours before operation�
28
● Pull the power cord out of the storage
compartment (21) and plug in� Adjust the
length of the cable by pushing it back in
or pulling it out� The easiest way to do
this is to place the appliance so that its
back is flush with the edge of the counter
and either pull the cable downward or
push it upward�
● Install the milk frother. Operate the
machine only after the milk frother (6) has
been fully assembled and installed�
● Lift the lid of the water tank (18)�
● Remove and rinse the water tank (17)
and fill it with fresh cold water.
Do not fill above the max mark�
● Replace the water tank (17) and push it
firmly downward into place.
● Close the lid of the water tank (18) again�
● Fill the bean container (1) with coffee
beans (for preparation using ground
coffee, see "Preparation using
ground coffee").
● Press the power switch O / I (9)� The
display (16) shows the menu for setting
the display language�
● Select the required display language with
the upper rotary knob (15)�
● Place a receptacle under outlet (6a)�
● Press the start button (10)�
The language you selected is saved�
The appliance heats up and rinses� Some
water will run out of the coffee outlet�
When the drink selection menu is shown in
the display, the appliance is ready for use�