Adjusting The Grinding Unit - Siemens TE515 Série Mode D'emploi

Water hardness: The water hardness
setting can be adjusted on this appliance�
It is important to set the water hardness
correctly, so that the appliance indicates
accurately when the descaling programme
should be run� The factory setting for the
water hardness is 4�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier� If a water softener is
installed in the house, please set the water
hardness to level 3�
Dip the test strip briefly in water, gently
shake off any drips, and check the result
after one minute�
Level Water hardness
German (°dH)
1 1-7
2 8-14
3 15-21
4 22-30
Drink counter: This displays how many
drinks have been dispensed since the appli-
ance was first put into operation.
French (°fH)
1-13
14-25
26-38
39-54
Adjusting the
grinding unit
The rotary selector (3) adjusts the grind
settings from coarse to fine.
A Warning!
Adjust the grinding unit only while it is
running! Otherwise the appliance may
be damaged� Do not reach into the
grinding unit�
● While the grinding unit is running, adjust
the rotary selector (3) from fine (a: Turn
anticlockwise) to coarse (b: Turn clock-
wise) as required�
Note: The new setting will not become
apparent until after the second cup of
coffee�
Note: If the message Adjust coarseness!
appears in the display, the grind setting
for the coffee beans is too fine. Adjust the
grinding unit to a coarser setting�
Tip: For dark roast coffee beans, choose a
finer grind, for lighter beans a coarser grind.
en
31