Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2.
Place a central position of the X-LOCK wheel on
the holder.
Make sure the X-LOCK wheel is parallel to the
flange surface and with the correct side facing up.
3.
Push the X-LOCK wheel into the holder. The
catches snap into the lock position with a click and
fix the X-LOCK wheel.
3
4
Fig.15
► 1. X-LOCK wheel 2. Holder 3. Flange surface
4. Catch
4.
Make sure the X-LOCK wheel is fixed correctly.
The surface of the X-LOCK wheel is no higher
than the surface of the holder as shown in the
figure.
If not, the holder must be cleaned or the X-LOCK
wheel must not be used.
Fig.16
► 1. Surface of the holder 2. Surface of the X-LOCK
wheel
1
2
1
2
To remove the X-LOCK wheel, push the release lever
from A side to lift B side, then pull the release lever from
B side as illustrated.
The X-LOCK wheel is released and can be removed.
A
Fig.17
► 1. Release lever
Installing dust collecting wheel
guard for cutting-off
Optional accessory
With optional accessories, you can use this tool for
cutting stone materials.
Fig.18
NOTE: For information how to install the dust col-
lecting wheel guard, refer to the manual of the dust
collecting wheel guard.
14 ENGLISH
1
B
Publicité
Table des Matières
