Optional Accessory - Makita GD0603 Manuel D'instruction

1
2
► 1. Wrench 2. Collet nut 3. Spindle 4. Collet cone
NOTE: If you cannot insert the wheel point into the
collet nut after loosening the collet nut, the collet cone
may obstruct the wheel point. In that case, remove
the collet nut and reposition the collet cone.
The wheel point should not be mounted more than 10
mm (3/8")from the collet nut. Exceeding this distance
could cause vibration or a broken shaft.
10 mm (3/8")
OPERATION
CAUTION:
Apply light pressure on the tool.
Excessive pressure on the tool will only cause a poor
finish and overloading of the motor.
CAUTION:
The wheel point continues to
rotate after the tool is switched off.
4
3
1
Turn the tool on without the wheel point making any
contact with the workpiece and wait until the wheel point
attains full speed. Then apply the wheel point to the
workpiece gently. To obtain a good finish, move the tool
in the leftward direction slowly.
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
Dressing wheel point

Optional accessory

When the wheel point becomes "loaded" with various
bits and particles, you should dress the wheel point with
the dressing stone.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
6 ENGLISH