Chicco TRiO LOVE UP LIGHTNAP Mode D'emploi page 15

below before positioning the carry cot in the car:
BUCKLES FOR CAR SEAT BELTS
18. To fasten the two buckles on the pins located at the
ends of the carry cot (fig. 18A), insert each buckle in the
pin pushing it (fig. 18B) and pulling the buckle down
until you hear a click (fig. 18C).
WARNING! Do not assemble the buckles backwards! (fig. 18D).
The carry cot is now ready to be positioned in the car.
FASTENING THE CARRY COT IN THE CAR
19. To fasten the carry cot to the rear seat, position it at the
centre, aligned with the car seat, and fasten it using the
seat belts of the two outer seats (fig. 19).
20. If the rear seat of your car has a 3-point seat belt in the
middle seat too, the carry cot can be fastened also shift-
ed to one side occupying the middle seat and lateral
seat using the seat belts of these two seats (fig. 20).
21. Pull and fasten the two seat belts in the seat's buckles
(fig. 21).
Recline the carry cot backrest completely
WARNING! Never use the carry cot in the car with the
backrest raised! Safety is not guaranteed!
Follow the steps below on both sides:
22. Take the seat belt and make a loop (fig. 22);
23. Take the car kit buckle and rotate the buckle's red bar
outward (fig. 23).
24. Insert the loop you've made in the seat belt in the buck-
le (fig. 24A – 24B) and rotate the red bar to its initial po-
sition so that it fits inside the loop (fig. 24C).
25. Pull the seat belt toward the retractor pressing the carry
cot against the seat so that it is fastened well (fig. 25A).
WARNING! Make sure that the carry cot is fit against the
backrest and seat.
WARNING! Make sure that the belts are tensioned (fig. 25B).
REMOVING THE CARRY COT FROM THE CAR SEAT
Follow the steps below on both sides.
26. Unfasten the buckle from the carry cot pulling the buck-
le's red tab outward and pushing upward (fig. 26) to re-
lease the carry cot from the seat belt. The buckle is left
fastened to the seat belt.
WARNING! Never use the seat belt to fasten passenger
without removing the CAR KIT buckle: it can be dangerous!
27. To remove the buckle from the belt, loosen the loop in
the belt (fig. 27A) and rotate the red bar so that it comes
out (fig. 27B).
FASTENING THE CARRY COT TO THE STROLLER
Prepare the stroller to assemble the carry cot according to
the stroller's instructions.
For use with the stroller, make sure to remove the safety
belts following the steps in paragraph CARRY COT SAFETY
HARNESS AND COMFORT KIT in reverse order.
WARNING! The restraint system must be removed when
the product is used outside the car.
WARNING! To fasten the carry cot to the stroller structure,
remove the seat first.
28. Hold the handle in carrying position (vertical) and posi-
tion the carry cot in the vertical joints making sure that
the two vertical mechanisms are outside the carry cot
until you hear the click confirming fastening. Place the
carry cot with the baby's feet end facing the stroller's
handle (fig. 28A). To facilitate fastening the carry cot on
the stroller, there are labels with instructions on both
sides of the fabric showing you the correct alignment of
the carry cot with the fasteners (fig. 28B).
WARNING! Before using, make sure that the carry cot is
properly locked on by pulling on it upwards.
REMOVING THE CARRY COT FROM THE STROLLER
29. Position the handle in the carrying position (vertical),
pull the button on the front of the carry cot outwards
(fig. 29A) and while keeping the button raised remove
the carry out from the stroller structure by pulling it up
(fig. 29B).
WARNING! The fastening and releasing operations can be
carried out also with your child inside the carry cot; howev-
er, these operations may be more difficult to execute due
to the child's weight. Pay attention when carrying out the
above mentioned operations.
Important Note: The images and instructions in this man-
ual refer to a single carry cot version. Some of the compo-
nents and functions described here may vary depending
on the model purchased.
WARRANTY
The product is guaranteed against any conformity defect
in normal conditions of use as provided for by the instruc-
tions for use. The warranty shall not therefore apply in the
case of damages caused by improper use, wear or acciden-
tal events. For the duration of the warranty on conformity
defects please refer to the specific provisions of applicable
national laws in the country of purchase.
15