Chicco TRiO LOVE UP LIGHTNAP Mode D'emploi page 13

• The carry cot is not designed for
children to sleep in for a long pe-
riod of time: this product is not a
substitute for a cot.
• It is recommended to air the carry
cot in case it has been used for a
long time.
• Before lifting or transporting the
carry cot, the base needs to be ad-
justed to the lowest position.
• The child's head in the carry cot
must never be kept lower than the
child's body.
• WARNING! The restraint system
must be used only when transport-
ing your child in the car.
• WARNING! The restraint system
must be removed when the prod-
uct is used outside the car.
• Keep the product out of children's
reach when it is not being used.
TIPS FOR CLEANING AND MAINTENANCE
This product requires periodical maintenance. Cleaning
and maintenance operations must be performed exclu-
sively by an adult.
CLEANING
Clean the fabric parts using a wet sponge and neutral soap.
Periodically wipe clean plastic parts with a soft damp cloth.
Always dry the metal parts to prevent the formation of rust
if the folding cot has come into contact with water.
WASHING
The external/internal lining of the carry cot and the mat-
tress are removable and washable; in order to remove
them, please refer to the paragraph REMOVING THE CARRY
COT LINING.
it is advised to carefully follow the washing instructions
shown on the item's label.
Below are the cleaning symbols and their meanings:
Hand wash
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
MAINTENANCE
Always let the metal dry. Do not submerge the carry cot in
water. Routinely wipe clean plastic parts with a soft damp
cloth. To avoid friction, ensure that the locking devices of
the carry cot and stroller are free from dust or sand. Do not
leave the product exposed to the sun for a long period
of time; the fabrics may discolour. Lubricate the moving
parts only if necessary, with a light application of a silicone
based lubricant. Do not use solvents or abrasive products
for cleaning.
CARRY COT FEATURES
The carry cot is comprehensive of the following compo-
nents: fabric lining, hood, cover, detachable mattress, com-
fort kit (two shoulder straps and a crotch strap), and detach-
able kit for car transportation.
1. The carry cot is supplied with the fabric lining already
fitted (fig. 1).
HOOD
The carry cot is equipped with a sun canopy and windshield
that can be adjusted to various positions, while the upper
part features an opening to reach the carrying handle.
2. To fit the hood on the carry cot, lift the carrying handle of
the carry cot into vertical position (fig. 2A), place the hood
on the handle and fasten the four snap buttons on the
edge of the hood on the matching buttons in the fabric of
the carry cot (fig. 2B).
3. To fasten the hood to the handle, wrap of the fabric of the
hood around it, fasten the two snap buttons on the joint
(fig. 3A) and close the Velcro straps around the handle
(fig. 3B). To complete the operation, pull the edge of the
hood fabric beyond the handle (fig. 3C).
REAR OPENING
4. To ensure proper ventilation, the carry cot features a rear
opening; to open it, just fold the flap on the upper part of
the carry cot (fig. 4).
HOOD
5. The internal part of the hood features a fabric ring that
allows you to hang soft toys (fig. 5).
COVER
6. Fasten the cover in place using the two side snap-but-
tons (fig. 6A) and insert the eyelet over the relative pin
located near the baby's feet (fig. 6B). Then fasten the fab-
ric flap of the cover to the hood, on both sides, using the
two snap buttons (fig. 6C). To ensure the utmost safety of
your child, you can use the fabric flap in vertical position
fastening it to the relevant holes (fig. 6D).
ADJUSTABLE BACKREST - COMFORT SYSTEM
7. The carry cot's backrest can be adjusted gradually. To incline
or recline the backrest, use the wheel located on the outer
part of the carry cot near the baby' s feet (fig. 7).
CARRYING HANDLE
8. The carry cot features a comfortable carry handle that
can be adjusted in three positions (fig. 8): A) Transport B)
Middle C) Rest.
9. To put the handle in the vertical position, grasp it in the
centre and pull it up until you hear a click (fig. 9 A); to re-
turn the handle to middle position, press the two buttons
on the joint of the handle at the same time (fig. 9B); to go
13