Publicité
Page 3 of 5
Picture 3
•
If fitting R&G mini indicators (R&G mini indicator product code RG371 for LED type, or
RG372 for Aero Style LED type), resistors to control the indicator flash rate may be
required (available separately, product code RGR0001).
•
Remove the original indicators using a 19mm spanner to loosen the securing nuts, as shown in
picture 1, making sure to disconnect both wiring connectors, as shown in picture 2.
•
Slide a washer (item 2) over the exposed thread of the indicators of choice, then offer these up to
the indicator mounting block, as shown in picture 3, fitting another washer over the inner face of
the mounting block as shown in picture 4, then secure with the included nuts.
•
Slide a wiring cover (item 4) over the indicator wiring so that the securing nuts are neatly covered
(a small amount of dish soap may help with this). A length of heatshrink (item 3) can then be slid
over the indicator wiring, heating with a heat gun or similar until the wires are neatly wrapped.
•
Fit an indicator connector adaptor (item 1) to the bullet connectors of each indicator (and resistors
if required), then fit to the respective original indicator connectors.
•
Test operation before riding.
The catalogue description and any exhibition of samples are only broad indications of the Products and R&G may make design changes which do
not diminish their performance or visual appeal and supplying them in such state shall conform to the order. The Buyer acknowledges no
representation or warranty (other than as to title) has been given or will apply to the Products other than those in R&G's order or confirmation and
the Buyer confirms it has chosen the Products as being of merchantable quality and suitable for its particular purposes. Where R&G fits the
Products or undertakes other services it shall exercise reasonable skill and care and rectify any fault free of charge unless the workmanship has
been disturbed. The Buyer is responsible for ensuring that the warranty on the motorcycle is not affected by the fitting of the Products. On return
of any defective Products R&G shall at its option either supply a replacement or refund the purchase money but shall not be liable if the Products
have been modified or used or maintained otherwise than in accordance with R&G's or manufacturer's instructions and good engineering practice or
if the defect arises from accident or neglect. Other than identified above and subject to R&G not limiting its liability for causing death and personal
injury, it shall not be liable for indirect or consequential loss and otherwise its liability shall be limited to the amounts paid by the Buyer for the
Products or the fitting or service concerned. These terms do not affect the Buyer's statutory rights.
Returns must be pre-authorised (if not pre-authorised the return will be rejected). Goods may only be returned direct to us if they were purchased
direct from us (customer must prove if necessary). Otherwise to be returned to original vendor. Goods must be in re-sellable condition, in the
opinion of R&G Racing. All returns are subject to a 25% restocking and handling fee (25% of the gross value exc. P&P – at the prevailing price at
time of purchase). The customer must pay any and all carriage charges. No returns of discontinued products, unless within 14 days of purchase.
This policy does not affect your statutory rights and does not refer to faulty goods.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
FITTING INSTRUCTIONS
ISSUE 1 – 08/06/2020 (FB)
CONSUMER NOTICE
R&G RACING RETURNS POLICY (NON-FAULTY GOODS)
R&G Racing
Picture 4
www.rg-racing.com
Email:
FAP0032
info@rg-racing.com
Publicité
